FJ-15 Advance Manual Finger Jointing System

Simple in design, easy to operate and requires very little maintenance.
Can do horizontal or vertical jointing up to 6 inches.
High tolerance of the dimension of raw material, can join block as short as 4.5”.
Spirally stacked carbide tipped cutters are to set up, cuts smoothly, and virtually eliminates rip-out, tear-out and vibration.

The most economic systems to reclaim valuable wasted wood

CKM offers three levels of systems; the automatic system for high production, the semi-automatic system for medium production, and the manual system for low to medium production.
The FJ-15 is very competitively priced. It is ideal for the shops where production need do not justify the cost of a high production system.
FJ-15A consists of a left-hand finger shaper (F-C51), a glue unit (F-G01), and a assemble press (F-A07), The production rate for FJ-15A is about 5000 linear feet per shift.
FJ-15B consists of FJ-15A and a right-hand finger shaper (F-C52). The addition of right-hand shaper can increase the production to over 10000 linear feet per shift.

The Finger Shaper consists of a trim saw, a shaper, and a moving table which cuts the blocks in batches.
The batch system has proven to be the most effective system. The batch system allows usage of short blocks as well as longer lengths. The system also allows the same machine to produce vertical and horizontal joints.

Spirally stacked carbide tipped cutters is easy to set up cuts smoothly. and virtually eliminates rip-out, tear-out and vibration.

This gluing unit applies glue to the shaped blocks before Assemble Press.

This Assemble Press consists of an automatic feed unit, a cut-off saw, and a hydraulic press. It can assemble up to 2 pieces of 14.5 feet board per minute.
The cycle of feeding, cutting off at length, pressing and ejection is automatic and is controlled by PLC.
The powerful hydraulic press ensures tight and strong joint.

FJ-15A (Manual Finger Jointer System | Single Shaper)

F-C51 Finger Shaper (Left End)
F-G01 Gluing Unit
F-A07 Assemble Press

FJ-15B (Manual Finger Jointer System | Double Shaper)

F-D05
F-C51 Finger Shaper (Left End)
F-C52 Finger Shaper (Right End)
F-G01 (Gluing Unit)
F-A07 Assemble Press

Finger Shaper
Model	F-C51 (Left) / F-C52 (Right)
Max: available width working table	450 mm
Range of material length	115 - 1000 mm
Range of material width	25 - 160 mm
Power Required
For trimming saw	5 HP (3 ph), 5 HP (1 ph)
For finger cutter	10 HP (3 ph), 7 1/2 HP (1 ph)
Dust outlet diameter	6" x 1, 4" x 2
Machine dimensions (L x W x H)	1780 x 840 x 1400 mm
Net weight	740 Kgs
Gross weight	820 Kgs

Assemble Press
Model	F-A07
Available length of product	4.5 M
Available thickness of product	60 mm
Available width of product	160 mm
Max: assembly pressure	0 - 100 kg/cm²
Hydraulic power unit	5 HP (3 ph), 3 HP (1 ph)
POWER REQUIRED
For cut-off saw	5HP (3 ph), 5 HP (1 ph)
Machine dimensions( LxWxH )	6650 x 950 x 1400 mm
Net weight	1250 Kgs
Gross weight	1350 Kgs